#FT 991 YAESU PROGRAMMING SOFTWARE INSTALL#
#FT 991 YAESU PROGRAMMING SOFTWARE DRIVERS#

#FT 991 YAESU PROGRAMMING SOFTWARE INSTALL#

In a 'Generic' driver being installed by Windows which could result in issues later.ДЇollow the manufacturer's instructions to install the drivers, or, if you have problems locating or installing the drivers, please contact the device manufacturer's support team for assistance. Connecting the cable before installing the proper driver could result

#FT 991 YAESU PROGRAMMING SOFTWARE DRIVERS#

Insure you have installed the Virtual Com Port drivers for your radio or interface before connecting the USB Cable to the computer. This method requires a Virtual Com Port driver, which can be downloaded from the radio manufacturer's website. The USB interface provides for Rig Control and an Audio Codec for the radio's internal soundcard. If the cable you are currently using or plan to use doesn't have the ferrite chokes, it's recommended you purchase some of the 'snap-on' chokes that are available from or on eBay and attach them to the cable you are using. These chokes help prevent RF radiation, which may be present in any shack, from feeding back into the computer, which can sometimes cause some very strange behavior in the HRD software. Notice the 'Ferrite Chokes' on each end of the cable. SignaLink, Rig Blaster, Rig Expert, or other interface) is required because this USB cable provides the connection for the Rig Control and it also carries the Audio for the radio's built-in soundcard which is accessed by a 'USB Audio CODEC' once the proper driver from the radio's manufacturer is installed.Д«elow is an image of the USB cable we recommend.

The most common way of interfacing your radio to the computer is via a standard A/B type USB cable. Important: Please read and understand the instructions in this document prior to connecting your radio to the computer. Solution home Knowledgebase Radio Support FT-991 USB Configuration

Ft 991 yaesu programming software